Installation guide

22Installation Guide
GB
Plugthereceiverintothemainssocket.Startthereceiverwiththebutton“ON/
STANDBY”ontheremotecontrolorwiththebutton“POWER”onthefrontofthere-
ceiver.InthestandbymodetheLEDlightis“RED”,andintheoperatingmode“RED/
YELLOW”.
The receiver comes with pre-programmed television channels and is ready for use
immediately. If you want to see whether new channels are available, enable the channel
search feature. You can read more about this feature below.
To switch to standby mode, press the red button in the upper left corner of the
remote control. The current time is displayed. The receiver uses only about 2 watts
in standby mode. For current standards, this is a very low power consumption rate.
8.1 On-screen info display when changing channels
Each time you change the channel, an info screen is displayed for 5 seconds. This
screen provides the following information:
Name of channel
Current date
Beginning time and endtime of current/next program
Available memory
TXT symbol Displayed if the selected broadcast station offers teletext
EPG symbol Displayed if the selected broadcast station offers the
Electronic Programme Guide
Heart symbol Displayed if you have added this channel to a Favourites
List
Info About currently active Channel List
7. GETTING STARTED
8. USING THE RECEIVER