Manualshelf

User manual

ManualsBrandsDigital Blue ManualsComputer equipmentShow Pix
31323334353637383940
CHAPTER 3
SHOWPIX® Menu System
28 SHOWPIX® Pixelation Luminaire User Manual
By Parameter
This menu option lets you view the current DMX value for this fixture by parameter. The
parameters are grouped as:
• Chassis parameters
• Graphic Engine parameters
• Image A parameters
• Image B parameters
Note: Viewing DMX values by Parameter will only be valid if you are using
Standard Protocol.
Temperatures Menu
The SHOWPIX fixture contains temperature sensors that track current, maximum and minimum
temperatures produced in the unit. Sensors monitor the air temperature of the electronics
housing, and the fixture head.
Initially, the setting for current, maximum and minimum temperatures are equal. As the sensor
detects temperature changes, the fixture adjusts the minimum and maximum settings.
To view maximum temperature the Head reached since the last reset:
1. Press the Menu button to unlock the menu system or to move back up the system to the
top level menus.
2. Use the left and right arrows on the Center button to scroll to the INFORMATION MENU and
press the Enter button to select.
3. Use the left and right arrows on the Center button to scroll to the TEMPERATURES MENU and
press the Enter button to select.
4. Use the up and down arrows on the Center button to scroll to MAXIMUM. Press the Enter
button to select and view the temperature recorded in degrees centigrade for the topbox
and the head.
To reset all the temperature readings back to the current temperature:
1. Press the Menu button to unlock the menu system or to move back up the system to the
top level menus.
2. Use the left and right arrows on the Center button to scroll to the INFORMATION MENU and
press the Enter button to select.
3. Use the left and right arrows on the Center button to scroll to the TEMPERATURES MENU and
press the Enter button to select.
4. Use the left and right arrows on the Center button to scroll to RESET TEMPERATURE. Press the
Enter button to select. The display will read NO. Use the up and down arrow to scroll to YES
and hold for 5 seconds to reset all sensors to the current temperature in centigrade.