User manual

SHOWPIX® Pixelation Luminaire User Manual 7
Chapter 2
Setup and Configuration
SHOWPIX
®
fixture setup includes mounting, connecting to power and DMX
linking and configuration.
Use the following steps to set up and configure your SHOWPIX
®
fixture:
1. Unpack the fixture.
2. Install power cord cap for your location.
3. Mount the fixture upright or suspended from a standard truss.
4. Connect the fixture to a DMX controller via DMX cabling.
5. Connect the fixture to power.
6. Configure the fixture for DMX control.
Unpacking the Fixture
The SHOWPIX
®
fixture is transported in a shipping box or road case specifically designed to
protect the product during transport. When unpacking, inspect the fixture for physical damage
to components. High End Systems
®
assumes no responsibility for products that are damaged
during transport. Return a product for repair in its shipping box or road case. Before sending
anything to the factory, call your High End Systems dealer/distributor for a Return Material
Authorization (RMA) number. The factory cannot accept any goods shipped without an RMA
number.
Pan and Tilt Locking
The SHOWPIX fixture ships with pan and tilt latches locked. You can unlock/adjust these latches
to stabilize the fixture for mounting and re-packing in a roadcase.
Note: Disengage the Pan and Tilt locks before operating the fixture.
Tilt Lock
Pan Lock