BW600 USER GUIDE © Copyright 2021 Digital Barriers
EDGEVIS BODY WORN CAMERAS Table of Contents INTRODUCTION ...................................................................................................................................... 3 BW600 OVERVIEW................................................................................................................................ 3 CHARGING............................................................................................................................................ 4 CONFIGURATION .......
EDGEVIS BODY WORN CAMERAS Introduction Thank you for selecting an EdgeVis BW600 live streaming body worn camera. This guide will describe the configuration and general usage of the BW600.
EDGEVIS BODY WORN CAMERAS Charging Configuration For more information about setting up VideoVault, refer to the VideoVault User Guide. Inserting a SIM Card The BW600 requires a nano-SIM card. The SIM card slot is situated underneath the battery. The front case panel and the battery must be removed to access the SIM card. 1) 2) Follow the instructions in the Battery Replacement section to remove the battery. The SIM card slot has a locking tray. Slide the tray to the right to unlock.
EDGEVIS BODY WORN CAMERAS 3) Insert a nano-SIM card into the SIM slot. Check that the notch on the SIM card aligns with the notch on the bottom left of the slot. 4) Make sure that the SIM card fits within the slot then close the tray. Lock the tray by sliding it to the left. Do not force the tray. If it does not slide easily then open the tray again and check that the SIM card is sitting correctly.
EDGEVIS BODY WORN CAMERAS 1) 2) Crocodile clip KlickFast™ Adapter for connection to standard KlickFast™ mounts. Attaching the Crocodile Clip: 1) 2) 3) Turn the camera so the LCD screen is facing upwards. The U-shaped mount is above the LCD screen. Align the metal clip of the crocodile clip with the camera mount, then slide the clip downwards until it clicks into place. The centre of the clip should engage with the notch on the back of the BW600.
EDGEVIS BODY WORN CAMERAS 2) The assigned camera will show a flashing white light to assist with locating it. The camera selected for assignment will be based on the current state of cameras in the pool. The same camera will not be assigned every time. 3) Remove the assigned camera from the docking station by pulling it upwards. 4) The screen on the camera will update and show the camera viewpoint to indicate that it is in operational mode.
EDGEVIS BODY WORN CAMERAS (2) this device must accept any interference received, including interference that may cause undesired operation. This device contains module FCC ID: 2ABOE-BW600 Further Reading For more information, please visit the EdgeVis Support website https://tvi-support.digitalbarriers.
SAR Information Statement The product is designed and manufactured not to exceed the emission limits for exposure to radiofrequency (RF) energy set by the Federal Communications Commission of the U.S. Government. These limits are part of comprehensive guidelines and establish permitted levels of RF energy for the general population. The guidelines are based on standards that were developed by independent scientific organizations through periodic and thorough evaluation of scientific studies.
FCC STATEMENT : This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
