User guide

ManualsBrandsDigital Audio Labs ManualsMixing consolesLIVEMIX - 32 Mix Distributor

LIVEMIX MIX-16/32

MIX-16/MIX-32 FIRMWARE UPDATE INSTRUCTIONS

The MIX-16/MIX-32 can be updated with a CS-SOLO/CS-DUO

or a PC application.

You can update with a CS-SOLO or CS-DUO if:

• The MIX-16/MIX-32 serial number is greater than

12-02-01030

• The MIX-16/MIX-32 rmware is 1.01 or above

• The CS-SOLO/CS-DUO rmware is 1.31 or above

If your MIX-16/MIX-32 does not meet the criteria above, update with a Windows PC application.

In most cases, this will bring your MIX-16/MIX-32 up to date and subsequent updates can be

performed with the CS-SOLO/CS-DUO. For reference, both methods are listed below.

UPDATE FIRMWARE OF MIX-16/MIX-32 WITH THE PC APPLICATION:

1. Update all CS-SOLOs and CS-DUOs to the latest version per the instructions above.

2. Download the MIX-16/MIX-32 Update Application from http://www.digitalaudio.com/support.

3. Connect the USB port on the MIX-16/MIX-32 to a Windows computer.

4. Wait for MIX-16/MIX-32 drivers to fully install.

5. Run MIX-16/MIX-32 Update Application. A second set of drivers will be installed at the start

of this process and may take a few minutes. Once the updater has started, a progress bar will

appear. Do not turn off the power until the update is complete or you may damage the unit.

6. PRESS Finish.

7. Disconnect the MIX-16/MIX-32 from the PC and verify the update was successful by checking

the rmware version with the CS-SOLO/CS-DUO.

UPDATE MIX-16/MIX-32 FIRMWARE WITH A CS-SOLO OR CS-DUO:

1. Download the latest rmware: http://www.digitalaudio.com/support.

2. Unzip the rmware zip le and copy the LMUPDATE folder to the

root directory of a USB ash drive (FAT Format). Please verify the

LMUPDATE folder is not in another folder.

3. Go to Livemix Version Info by pressing Mix Tools, Global

Conguration and then Livemix Version Info.

4. PRESS Update MIX-16/MIX-32 Firmware.

5. PRESS Yes to update, or No to cancel.

6. Insert USB ash drive containing the update, when prompted. PRESS

Continue or Exit to cancel. Once the update has begun, do not turn

off the power to the MIX-16/MIX-32 or you may damage the unit.

NOTE:

If updating with the

CS-SOLO or CS-DUO

does not work, please

use the PC Application.

Some updates take a

while to complete. If

updating the MIX-16/

MIX-32 from the

CS-SOLO/CS-DUO, it

works best to have only

one personal mixer

connected.