User guide

LIVEMIX CS-DUO

ACCESSORY: FP-2 FOOT PEDAL

The optional FP-2 Foot Pedal accessory can be connected

to the ¼” TRS connector on the Livemix personal

mixer rear panel. The foot pedal allows hands-free mix

adjustment or intercom activation.

SETTING UP THE FP-2 FOOT PEDAL

1. IN: Connect a ¼” TRS cable to the Foot switch

connector to the personal mixer. Make sure the cable

is a TRS and has Tip, Ring, and Sleeve. A standard TS

or guitar cable will not work with the FP-2.

2. A/B Switch ( CS-DUO ONLY): Depending on if you

are using the A or B side for mixing on the CS-DUO,

set this switch to MIX A or MIX B. This switch is

inactive on the CS-SOLO.

3. THRU (CS-DUO ONLY): The FP-2 THRU connector allows you to connect two foot pedals to

one CS-DUO; one for MIX A and one for MIX B. Use a TRS cable to connect the  rst pedal to

the second pedal and assign the MIX A or MIX B switches accordingly.

USING THE FP-2 FOOT PEDAL - STANDARD MODE

The FP-2 foot pedal is controlled by either a TAP or a HOLD on one of the buttons. A TAP is a short

press, less than 1 sec in duration. A HOLD is a long press lasting more than a second.

TAP BUTTON 1: A short tap on button 1 will select the next channel on the Livemix personal mixer.

When you reach channel 24 it will select the Accessory Channels then cycle back to channel 1.

HOLD BUTTON 1: A long press on button 1 will return you to the ME Group. A second long press

will select channel 1. If a ME Group is not set up, holding button 1 will return you to channel 1.

TAP BUTTON 2: A short tap on button 2 will turn up the volume of the selected channel.

HOLD BUTTON 2: A long press on button 2 will reduce the volume of the selected channel. The

volume of the selected channel will continue to reduce as long as button 2 is held.

HOLD BUTTON 1 & BUTTON 2: A long press on both buttons simultaneously will activate the

intercom. You will need to hold both buttons down for a full second before the intercom activates.

The intercom will remain active until the buttons are released.

USING THE FP-2 FOOT PEDAL IN INTERCOM MODE

If using the FP-2 with the LM-MICPRE, an additional Intercom Mode is available. This can be

selected on the External Mic Setup screen in the Single Channel View of the Intercom Channel. In

Intercom mode:

BUTTON 1: Functions the same as the Intercom button on the personal mixer. It will follow the

Always on/Latch/Push to Take modes as selected in the External Mic Setup.

BUTTON 2: Adjusts the volume of the ME group. TAP to increase the volume. HOLD to decrease

the volume.

NOTE:

The only foot pedal that will function

with the CS-SOLO or CS-DUO is the

Livemix FP-2. Third party foot switches

will not work. The FP-2 is available from

an authorized Digital Audio Labs dealer.