User guide
LIVEMIX CS-DUO
51
LIVEMIX FIRMWARE INSTRUCTIONS
Firmware updates add features and ensure compatibility with all parts of the Livemix system.
Checking the rmware version of your Livemix system is detailed in the “Livemix Version Info”
section. Please visit http://www.digitalaudio.com/support to verify if your Livemix system has the
most current version, as listed on the Livemix Version Info screen on all CS-SOLOs and CS-DUOs.
PREPARING A USB FLASH DRIVE
To update the CS-SOLO or CS-DUO, you will need a USB ash drive that has been FAT formatted.
Other le systems will not work.
CS-SOLO/CS-DUO UPDATE INSTRUCTIONS
TO UPDATE THE FIRMWARE OF THE CS-SOLO/CS-DUO:
1. Download the latest rmware from
http://www.digitalaudio.com/support.
2. Unzip the rmware zip le and copy the LMUPDATE folder to the root directory of a USB ash
drive. Please make sure the LMUPDATE folder is not in another folder.
3. Insert the FAT formatted USB ash drive into the USB port on the personal mixer. The rmware
update process will automatically start by presenting you with a pop up display.
4. Press YES to begin. If you do not want to update the rmware, press NO. Once the rmware
update has started, do not turn off the power to the CS-SOLO/
CS-DUO or MIX-16/MIX-32 as it may cause damage.
5. When prompted, remove the USB ash drive.
6. The CS-SOLO/CS-DUO will now update. When the update is
complete, the personal mixer will reboot.
Perform this update on each CS-SOLO and CS-DUO in the system
for maximum compatibility and consistency.
CS-SOLO FIRMWARE UPDATE TROUBLESHOOTING
If the rmware update process doesn’t start after following the
steps above, you can enter rmware update mode by doing the
following:
• Unplug the network cable to turn the CS-SOLO off.
• Insert the USB drive with the rmware, downloaded per the instructions in steps 1 and 2 above.
• PRESS and HOLD the Intercom button on the CS-SOLO. Continue to HOLD the Intercom
button and reconnect the network cable to power the CS-SOLO on.
• Follow rmware update instructions on the screen.
NOTE:
For updates to the MIX-16/
MIX-32 and the CS-SOLO and
CS-DUO, the MIX-16/MIX-32
should be updated rst.
Some updates take a while
to complete. If updating
the MIX-16/MIX-32 from
the CS-SOLO or CS-DUO, it
works best to have only one
personal mixer connected to
the system.