User guide

LIVEMIX CS-DUO
48
LIVEMIX DATA
IN
12VDC
3.33A
DA-816
BALANCED +4dBu LINE OUT
USB
WIRELESS TRANSMITTER 1WIRELESS TRANSMITTER 2
NOTE:
Observe the VU meters on the connected wireless
transmitters or devices. The DA-816 plays audible tone
beeps in this mode to conrm the intended signal chain is
setup properly.
The Output ID is a great way to:
• Quickly ensure musicians are given the correct wireless
body packs and are assigned to the correct personal
mixer on stage.
• Test which device is connected to the DA-816 outputs.
• Verify proper connection from DA-816 to external
devices.
DA-816 SOFTROUTE™
The DA-816 provides 8 stereo balanced outputs for
sending personal mixes to wireless in-ear transmitters,
powered monitors or powered house speakers. See the
DA-816 User Guide for more information.
From the Global Conguration screen, PRESS DA-816 SoftRoute to enter the DA-816 setup. You can
enter these screens even if you do not have a DA-816 connected. Assignments will be saved with
the Global Template.
NOTE: A Livemix personal mixer must be plugged into a MIX-16 or MIX-32 port to route audio to
an external device. If a mix that is assigned to a DA-816 output is physically disconnected or not
present, audio will not be routed.
OUTPUT ID FEATURE
The Output ID feature sends a test tone to the selected DA-816
Output. This allows you to verify that the desired external device
is connected to the selected output.
1. PRESS Output ID. The Output ID button will ash.
2. SELECT an Output. The cell will turn gray and the
corresponding LED on the DA-816 front panel will ash and
a test tone will be sent to output. The Output ID feature can
be used with multiple outputs at the same time.
3. PRESS Output ID again to exit this mode.