User guide
LIVEMIX CS-DUO
15
USING THE OPTIONAL LM-MICPRE
The LM-MICPRE is am optional microphone preamp
for using an external dynamic mic as an alternative
to the built-in intercom mics. Using an external
dynamic microphone as the intercom mic will provide
a higher quality intercom with signicantly reduced
background noise.
ATTACHING THE LM-MICPRE
1. Connect the included USB cable and 1/8” TRS
cable to the LM-MICPRE and feed the loose
ends through the MT-1.
2. Connect the USB cable to the personal mixer
USB port (front on the CS-SOLO, back on the
CS-DUO) and the 1/8” TRS cable to the AUX-IN port.
3. If using the Livemix MT-1 mount, position the LM-MICPRE with the threaded mount holes
“inside” the MT-1. Use either the thumbscrews or Phillips head screws to fasten. If your
Livemix personal mixer is not mounted on a stand, use the Phillips head screws and attach the
rubber support feet.
4. Connect a dynamic microphone to the XLR connector on the LM-MICPRE with a standard XLR
cable (not included).
CONFIGURING THE LM-MICPRE & EXTERNAL
MICROPHONE
1. PRESS Accessory Channels on the Channel
Overview.
2. PRESS and HOLD the Intercom Channel button.
3. PRESS LM-MICPRE so the cell is gray and says
“LM-MICPRE On”.
4. PRESS External Mic Setup.
5. Speak into the external mic while adjusting the
gain knob on the LM-MICPRE. The Mic Level
on the VU should be in the yellow range when
speaking at normal stage levels.
NOTE: If some users are using the built-in intercom and some are using external microphones, you
may need to adjust the gain knob on the LM-MICPRE to match respective intercom volume levels.
INTERCOM BUTTON
When using the LM-MICPRE function, the CONTROL button can be congured in one of three
different modes. When the intercom is active, a white indication will illuminate on the Status Bar
and an active indicator will appear on the Intercom Channel cell on the Accessory Channels page.
CS-SOLO PICTURED