User`s manual

DIGITAL I/O RCA jack to the corresponding digital input jack of your digital Enhanced

Audio Recorder.

3. Connect your stereo headphones to the PHONES jack on the PCAP II Plus external processor

front panel as shown in Figure 3-1. Make sure that the MONITOR pushbuttons are set to

OUTPUT, LEFT, and RIGHT (the three buttons are “out, in, and in”, respectively). Turn the

phones VOLUME control to MIN. It is also recommended that headphones be connected to

the Enhanced Audio Recorder's headphone jack to confirm that the output signal is being

properly recorded.

4. With the installation procedure in Section 2.2: complete, run the PCAP II Plus Master

Control program by double-clicking on the screen icon. It may require several seconds for the

program to load and initialize the external unit.

5. With the PCAP II Plus Master Control Panel displayed on your PC screen, insert some

recorded audio material into the Source Audio Player, then press the PLAY button.

6. With the audio now flowing into the PCAP II Plus, adjust the LEFT and RIGHT INPUT

LEVELS controls on the external processor front panel until the Input Levels bargraphs on the

PCAP II Plus Master Control Panel indicate GREEN with occasional peaks in the YELLOW

range. Note that some monaural material may not have audio present on the right channel.

7. With the phones VOLUME initially set to MIN, place the stereo headphones on your ears and

slowly adjust the phones VOLUME for comfortable listening.

NOTE: If you wish to listen to the unprocessed analog audio going into the PCAP II Plus,

toggle the MONITOR switch on the external processor to INPUT (button “in”); this does

NOT work for digital input material. To listen to the PCAP II Plus output, toggle the

MONITOR switch back to OUTPUT.

Figure 3-1 PCAP II Plus Connection Diagram

Computer

PCAP II Plus

Source Audio Player

Enhanced Audio Recorder

RS232 Interconnect

Headphones

Analog or Digital Input

Analog or Digital Output