Manualshelf

User`s manual

ManualsBrandsDigital Audio Corporation ManualsComputer equipmentPCAP II
21222324252627282930
9
Double click on this icon now to run the program. A screen similar to Figure 2-2 should appear:
Figure 2-2 Master Control Panel
If an error message is displayed, it is possible that the software is not configured for the correct COM
port (software defaults to COM1). If you know to which COM port the PCAP II Plus external
processor is connected, configure the Master Control program for the correct COM port by following
the procedure in Section 6.1: .
The PCAP II Plus system should now be installed and ready to run.