User`s manual

8
2.2: INSTALLATION PROCEDURE
1. Carefully remove the PCAP II Plus external processor from the shipping container. Confirm
that the AC power adapter, RS232 cables (2), demonstrator audio CD, and software disk(s)
are included. Also confirm that any optional accessories are included.
2. Connect the AC power cord to the PCAP II Plus rear panel POWER connector. Keep the
POWER switch OFF for now.
3. With the PCAP II Plus POWER switch OFF, plug the AC power adapter into an AC outlet.
4. With the computer turned OFF, connect the supplied RS232 cable between the CONTROL
PC RS232 connector on the PCAP II Plus rear panel and the desired computer COM port
(You may need to purchase an adapter if the COM port has 25 pins).
5. Now that they are connected together, switch ON both the PCAP II Plus and the
computer (sequencing is not critical).
6. Once Windows has booted up (Windows 95, 98, NT, 2000, or XP), insert the PCAP II
Plus Master Control software CD into the CD-ROM drive in your PC. The installation
program should automatically run. If not, use the Run command in the Windows Start
menu to browse the CD-ROM and select the setup.exe installation program.
NOTE: If for any reason you ever lose the software installation CD, or need to install
upgrades and/or bug patches, the latest version software is always available for
download at www.dacaudio.com; please contact DAC to obtain the proper
access information
7. The Setup Utility will now install the PCAP II Plus Master Control software on your PC's hard
disk. Please follow any instructions displayed by the Setup Utility.
Once the Setup Utility has completed installing the software, the icon in Figure 2-1 should
appear on your screen:
Figure 2-1 PCAP II Plus Master Control Icon