User`s manual

127
All Down 1dB Button: This button shifts all sliders down by 1dB from their current position; no
slider, however, will be allowed to go below -40dB. This button allows
the user to shift the entire equalizer curve down so that there will be room
to move one or more sliders up relative to the others.
Store Button: This button allows the user to store a slider configuration to a user-
specified disk file that will not be lost when the computer is tu
rned off.
Clicking this button brings up the dialog shown in Figure 3-12 of Chapter
3: .0. Save the configuration to any specified filename; clicking the Cancel
button exits the Store window without storing the slider configuration in
any of the memories.
Recall Button: This button allows the user to recall a previously stored slider
configuration from any of the saved disk files previously generated using
the Store button. Clicking this button brings up the window given in
Figure 3-13 of Chapter 3: .0.
NOTE: The curve that is in memory prior to recalling any specified file
EXCEPT the one named “Previous Filter Settings” will be stored in
“Previous Filter Settings” as part of the recall operation. Therefore, you
can reload the previous curve at any time by recalling the “Previous Filter
Settings” file.
EQ Active Button: Used to switch the equalizer in and out of the process without affecting
the operation of the other filters. Button LED is illuminated RED when
the equalizer is in the process, and is not illuminated (GRAY) when the
equalizer is out of the process.
NOTE: The EQ Active button is equivalent to, and linked with, the
Active button in the associated Equalizer block on the Master Control
Panel.
OK Button: Use either this button or the “X” button at the upper right corner of the
window to exit the dialog and return to the Master Control panel.