User's Manual

VuLink Operation & Installation Guide 860‐00198‐00 REV E
DigitalAlly,Inc.|VuLinkConfiguration 4‐9

DVM-800, DVM-250, and DVM-250Plus Device Configuration

If you have a Digital Ally DVM-800, or DVM-250 series video system, you must assign the
VuLink output trigger to an IF box input sensor. Using this configuration, the FirstVu HD will be
enabled to trigger device recordings and have a customized trigger name. From your VuVault
or Configuration Manager Settings tab, enable the desired sensor to be used with VuLink. This
customized name will become a searchable parameter if using VuVault.
1. Go to the IF Box Input Sensors section. Select the Sensor 5 row (or any unused sensor
input) and press Edit.
2. Select a name for the Sensor #5 VuLink sensor. Make the changes to this sensor input
as listed in the table below. When done, press Save.
Parameter Required User Setting
Name
Type a custom name here
Type
Triggered Sensor
Detection
Low to High
Threshold
High
Record Ends By
Record Button
Event Cameras
Use Default Cameras
LCD
On
3. You will need to re-activate your DVM with the new device configuration. Consult your
device Operation Guide for activation instructions.