User's Manual

RFID Card Programmer Operation Guide 860-00232-00 REV A
2
Section - 1: Operating Instructions
1. Connect the Digital Ally RFID Card Programmer to your VuVault PC using the supplied
USB cable. The green LED indicates that the unit has power.
2. Open VuVault and click on RFID Management in the Admin section.
3. Place the RFID card on the Programmer over the Digital Ally name.
4. Click Reset.
5. Fill in the Username box with the VuVault username for the person to whom the card
will be issued.
6. Click to program the RFID card with the new information. The Read and
Overwrite buttons will be grayed out for several seconds while the card is being
programmed.
7. When completed, click to verify that the information was written to the
card.