Specifications

Upgrade to New Control Board
ADDvantage-32 PLUS ● AC to DC Power Converter
12-10
5 After attaching the new electronics enclosure, a ribbon cable supplied as part of the
upgrade kit will be installed. The cable is part number B33178, which is visible on
the ribbon cable. One side of the cable plugs into connector J2 on the bridge interface
board. The cable will then be routed across the back of the drive cover and through
the slot into the electronics enclosure. The position and routing of the B33178 cable
is shown in Figure 12-6. Note that the connector on one end of the B33178 cable is
keyed and cannot be plugged into the J2 connector on the bridge interface board.
Figure 12-6. The B33178 ribbon cable plugs into connector J2 on the bridge interface
board and routes across the drive cover.