Tus neeg siv phau ntawv

ManualsBrandsDIGIT ManualsOtherDIGITUS DS-55122 4K HDMI Extender ntawm CAT/ IP (Teeb)

4K HDMI Extender via CAT/ IP (Set)

Manual

DS-55122 Rev. 3

Introduction

This HDMI Signal Extender extends your HDMI video/audio signal with of

resolution of 4K2K/30Hz up to 120m (394 feet) via single network cable.

Supports IR signal transmission, to control media playback of the signal

source device at the display location.

Summary of content (7 pages)

PAGE 1
4K HDMI Extender via CAT/ IP (Set) Manual DS-55122 Rev. 3 Introduction This HDMI Signal Extender extends your HDMI video/audio signal with of resolution of 4K2K/30Hz up to 120m (394 feet) via single network cable. Supports IR signal transmission, to control media playback of the signal source device at the display location.
PAGE 2
Important safety notice Please read below safety instructions carefully before installation and operation: 1. Please pay attention to all the warnings and hints on this device. 2. Do not expose this unit to rain, moisture and liquid. 3. Do not put any stuff into the device. 4. Do not repair or open this device without professional people’s guidance. 5. Make sure good ventilation openings to avoid product overheating damage. 6. Shut off power and make sure environment is safe before installation. 7.
PAGE 3
Specification Items Specifications HDMI Signal HDMI1.4, compatible with HDCP1.
PAGE 4
Panel Description 1. HDMI EXTENDER TX (Sender) ① HDMI signal input ⑤ Power input (DC5V) ② IR signal output to connect with ⑥ Data transmission light blaster extension cable ③ Reset ④ Power Light ⑦ Network link light ⑧ HDbitT signal output 2.
PAGE 5
Installation 2. Connections 2.1 Point to Point connection: Up to 120 meters transmission distance over single CAT 6 (High quality cable can reach 150 meters). HDMI EXTENDER TX (Sender) DVD HDMI EXTENDER RX (Receiver) HDMI IN HDMI OUT CAT5/5E/6 Cable TV 2.2 Network Switch/Router Connection: By using network switch/router/repeater, realize unlimited extension/distance.
PAGE 6
2.
PAGE 7
FAQ Q: TV display “Waiting for connection” on the right corner? A: Please check if the power supply of TX (Sender) and switcher (If used) is connected, and make sure connecting cable is firmly. Q: TV display “Please check the TX input signal”? A: Please check if there is a HDMI signal input of TX. Try to connect the signal source directly to display device to see if there is signal output from source device or change the signal source, HDMI wire and try again.