Specifications

DigiPoS Retail Blade
™
Manual
Peripheral Component Check
Once all diagnostic tests and voltage tests have been completed, it is necessary to
establish that the peripheral components of the system are not faulty and causing
apparent motherboard failures or preventing the DigiPoS Retail Blade™ from completing a
successful boot. Replace each key component using the following the procedure.
x Power down the system.
x Using full Electrostatic discharge (ESD) precautions remove the memory, hard
drive, floppy drive, CD ROM and any expansion cards installed.
x Re-Install each component individually, re-booting the DigiPoS Retail Blade™ each
time until all components has been refitted or until the suspect device has been
identified.
If none of the devices are found to be suspect, power down and replace the standard
peripheral devices and move to 1
st
level fault finding in the next chapter.
Page 96 of 103