Specifications

DigiPoS Retail Blade
™
Manual
BIOS Set-up Overview
The DigiPoS Retail Blade™ System contains its own permanently programmed SETUP
routine, which allows it to recognize and utilize the system's hardware. For example, one
can set the system to identify hard disk and floppy disk drive capacity, the type of video
being used, and the amount of memory installed. The BIOS (BASIC Input / Output
System) will read this information each time the system boots up.
As setting up the BIOS can be complicated, DigiPoS Systems advises that if any changes
to the BIOS are to be made, only competent qualified computer technicians undertake
them. There are settings within the BIOS that are operating system dependant and have
been set up in accordance to your systems configuration. Altering any of these settings is
not advised under any circumstances as any one setting incorrectly set can drastically
alter the performance of your DigiPoS Retail Blade™ and could invalidate the warranty.
The following screenshots are a guide through the CMOS set-up utility for the DigiPoS
Retail Blade™. If you need help at any time during this process, press F1 and a small
window will pop up describing the appropriate keys to use and the possible selections for
the highlighted item. To exit the help window press <Esc> or F1.
Please note that the default settings, (regardless of operating system installation which will
be covered later in this section) are shown in BOLD where appropriate.
Page 65 of 103