Specifications

DigiPoS Retail Blade
™
Manual
Typical Voltage Requirements
Device Examples
0
(Standard RS232)
51224
DigiPoS PoS Printer - - -
Y
Epson PoS Printer - - -
Y
DigiPoS Customer Display - - -
Y
Epson Customer Display -
-
-
Y
MSR swipe reader -
Y
--
MS9540 Voyager -
Y
--
MS7120 Orbit -
Y-
-
DigiPoS LCD Monitor - -
Y
-
External Modem
Y NNN
COM Port Voltage Selection
In order to output voltage to a specific COM port, the correct jumper has to be set on the
Power Distribution Board. The Power Distribution Board is located behind the Hard Drive
on the lower deck of the Retail Blade™. In order to access this area, the Retail Blade™
will have to be removed from the Host and the top cover removed to enable easy access.
Please observe the correct procedure for removing the Retail Blade™ as previously
described in this document.
The following picture shows all the possible combinations for powering the COM ports:
The ports are labelled as follows:
J1 = COM1
J2 = COM2
J3 = COM3
J4 = COM4
Page 49 of 103