Specifications

DigiPoS Retail Blade
™
Manual
Motherboard Jumper Settings
Jumpers
J3 – CMOS Reset
1-2 Normal Default
2-3 CLEAR CMOS
JB1 – Compact Flash Master / Slave Selection
1 – 2 CF Master Default
2 – 3 CF Slave
All other jumpers or switches not mentioned here are either not applicable or have
a reserved use. Do not alter these settings unless you have been instructed to do
so by DigiPoS Systems or an authorised DigiPoS Systems representative. Failure to
comply with this notice shall void all warranties.
Power Distribution Board Orientation
Page 39 of 103