Specifications

DigiPoS Retail Blade
™
Manual
e) Unlock the front cover (if necessary) and locate the two FRONT COVER RELEASE
TABS on the sides of the Retail Blade™. Depress both of these tabs at the same
time and remove the front cover from the Retail Blade™.
f) Using the BLADE REMOVAL GRIP BAR, pull the blade from the Host. Be careful to
support the back of the blade from underneath before you extract the blade fully
from the host.
Re-fitting the Blade in the Host
a) Offer the blade up to the host ensuring that the blade is correctly lined up with the
runners on each side of the interior of the host.
b) Before inserting the blade, make certain the PCI Riser Card (If fitted) lines up
correctly with the guide on the inside of the top cover.
c) Insert the blade into the host making certain that no cables foul the casing as the
blade is inserted.
d) When the blade makes contact with the connectors in the host, there will be
resistance. In order to ensure the blade connects properly, stop at this point and
pull the blade out again by approximately 5 ~ 10 centimetres. Then, using a
medium amount of force, push the blade quickly into the host. If the blade has been
fully inserted, it will be slightly recessed in relation to the top cover. If this is not the
case, repeat the above procedure.
e) If it appears that the blade is not seating correctly inside the host, DO NOT force
the blade into the host and contact your nearest DigiPoS Systems Office or
representative.
f) Before replacing the front cover, make certain the ATX power switch is switched
on.
g) If the PCI retaining screws were removed, re-fit them now and re-connect any
cables to the PCI devices (if applicable). It is also advisable at this point to check all
the cables plugged into the host to make certain that none have been disturbed
during either the removal or re-fitting of the blade. If any connector appears to be
loose or has been detached, STOP and contact your nearest DigiPoS Systems
Office or representative.
h) Located the external power supply and operate the neon switch to re-apply power
to the Retail Blade™. Now, boot the Retail Blade™ back up into your operating
system and conduct the necessary checks to make certain everything functions
correctly.
i) Finally, return the ATX switch back to its original position and replace the front
cover and lock it if necessary.
Page 33 of 103