User guide

Using Your DigiPoS PH-6000B

3-Position Keylock Operation

The DigiPoS PH-6000B has a keylock located on the front panel. This 3-

position keylock provides an additional layer of security to your DigiPoS

PH-6000B. Use the provided keys to control access to the power button,

reset button, and CD-ROM. Refer to the table below for information on

which components are accessible in each key position.

Typical POS Device Voltage Requirements

The DigiPoS PH-6000B provides three different voltage of PoweredUSB ports. With these

enhanced USB ports, you can connect peripheral devices directly to the DigiPoS PH-6000B

via a single USB cable for both power and data connectivity.

• 24volt PoweredUSB port (Red) - located on the rear side

• 12volt PoweredUSB port (Blue) - located on the rear side

• 5volt PoweredUSB port (Black/Orange) - located on the front side

The following table gives some examples of the supported devices by voltage.

Key Position Power Button Reset Button CD-ROM

1Locked modeXXX

2 Normal mode V V V

3 Standby mode V X X

Remark:

V: The button/device is accessible to the user.

X: The button/device is disabled.

Device Examples

(Standard RS232)

5V 12V 24V

DigiPoS PoS Printer ---Y

Epson PoS Printer ---Y

DigiPoS Customer Display -YY-

Epson Customer Display --Y-

MSR Swipe Reader -Y--

DigiPoS LCD Monitor --Y-