Operating instructions

Performance
Check and Adjustment-71380
b . Setthe POSITION
controls to midrange and
TRIG-
GERING MODE to
NORM .
N/ c . CHECK-Using
the TIME/DIV setting and
time-mark
generator settings from
Table 5-2, check
sweep accuracy
for 1 time
mark/division over the center 8
divisions with-
in the tolerance
given in Table 5-2 .
Set the POSITION
controls
and TRIGGERING
LEVEL control as necessary
for a
stable display aligned with
the vertical graticule
lines .
NOTE
If the time-mark generator used does
not have
1-2-5
sequence markers, apply 1 unit
markers in
place
of 2 unit markers and check
for 2 markers/
division, over the center eight
divisions of display,
to
the tolerances given in
Table 5-2 .
-/ B7 . CHECK MAGNIFIED
SWEEP TIMING
NOTE
The
tolerances in Table 5-3 are for an
ambient
temperature
range of +15 ° to +35 ° C . If
outside
this range, see the Specification section
for
applicable tolerances .
a . Center the display
horizontally on the graticule . Set
the MAG switch to X10 and
the SOURCE switch to
EXT .
b . Connect the time-mark generator
trigger output to
the EXT TRIG IN connector with a
50-ohm cable and
50-ohm termination .
/
Performance Requirement check ; see introductory
section .
TABLE 5-2
Sweep Timing
TIME/DIV
Time Markers
Tolerance
(+15 ° to
+35 °
C)
10 ns
10 ns Within
0 .2 div
20 ns
20 ns
Within 0 .2 div
50 ns 50 ns
Within 0 .2 div
.1 JAS .1 As
Within 0
.12 div
.2 ps
.2 ps
Within 0 .12 div
.5ps
.5 ps
Within 0 .12 div
1 As 1 us
Within 0 .12 div
2 ps
2 ps Within 0 .12
div
5 ps
5 ps Within 0
.12 div
lops
10 ps
Within 0 .12 div
20,4s
20 ps
Within 0 .12 div
50 ps
50 ps
Within 0 .12 div
.1 ms
.1 ' ms
Within 0 .12 div
.2 ms
.2 ms
Within 0 .12 div
.5 ms .5 ms
Within 0 .12 div
1 ms 1 ms
Within 0 .12 div
2 ms 2 ms
Within 0 .12 d iv
5 ms
5 ms
Within 0 .12 div
10
ms 10 ms Within
0 .12 div
20 ms
20 ms
Within 0 .12 div
50 ms 50 ms
Within 0 .12 div
.1 s .1 s
Within 0 .12 div
.2 s .2 s
Within 0 .12 div
.5s
.5s
Within 0 .12 div
1 s 1
s Within 0 .32 div
2 s
2 s Within 0
.32 div
5
s 5 s
Within 0 .32 div