Operating instructions

VOLTAGE
AND WAVEFORM
CONDITIONS
The voltages and
waveforms shown
were obtained with
the 71380 controls
set as follows :
TIME/DIV, 1
ms ; VARIABLE
(CAL
IN),
knob in
; MAG, X1 (button
in)
;
HOLD OFF, fully
counterclockwise
SWP CAL, midranged
;
POSITION,
midranged ; TRIGGERING
: LEVEL,
midranged ; MODE,
P-P AUTO ;
COUPLING, AC ; SOURCE,
LINE ; SLOPE,
+ .
Voltage
Conditions . The
voltages shown on the
diagram were obtained
using a digital
multimeter with a 10
MS2 input impedance
(Tektronix
DM 501
Digital Multimeter or
Tektronix 7D13
Digital Multimeter
used with readout
equipped, 7000-series
oscilloscope) .
Waveform
Conditions . The
waveforms shown
below were obtained
using a test oscilloscope
system with 10
M92 input impedance
and at least
60 MHz
bandwidth (Tektronix
7603 Oscilloscope,
7B53A Time Base,
and 7A13
Differential Comparator
equipped with 10X probe) .