User manual
60
www.digiop.com
APPENDIX G: SERVER HARDWARE TROUBLESHOOTING
Error Message Description
Seek error The operating system cannot nd a specic track on the oppy disk or hard drive.
Shutdown failure A chip on the system board might be malfunctioning.
Time-of-day clock stopped The battery might be dead.
Time-of-day not set-please run the System Setup program The time or date stored in System Setup does not match the computer clock.
Timer chip counter 2 failed A chip on the system board may be malfunctioning.
Unexpected interrupt in protected mode The keyboard controller may be malfunctioning or a memory module may be loose.
WARNING: Dell’s Disk Monitoring System has detected that
drive [0/1] on the [primary/secondary] EIDE controller is
operating outside of normal specications. It is advisable to
immediately back up your data and replace your hard drive by
calling your support desk or Dell
During initial startup, the drive detected possible error conditions. When your computer
nishes booting, immediately back up your data and replace your hard drive (for installation
procedures, see “Adding and Removing Parts” for your computer type). If no replacement
drive is immediately available and the drive is not the only bootable drive, enter System
Setup and change the appropriate drive setting to None. Then remove the drive from the
computer.
Write fault The operating system cannot write to the oppy or hard drive.
Write fault on selected drive The operating system cannot write to the oppy or hard drive.
X:\ is not accessible. The device is not ready The oppy drive cannot read the disk. Insert a oppy disk into the drive and try again.