User manual
33DIGIOP™ Control User Manual
SECTION 4: USING VIEWER
— Square –Click on the desired location on the image and then drag the mouse to dene a “square” region.
Square
Block
NOTE
Multiple blocks and squares can be added to a single image to create the motion sensitive regions you want. Blocks and squares
may overlap.
11. Check Move to move blocks and squares to new locations. You can also Delete them.
12. Place a check mark in View Search Process to view all video, not just the images where movement is detected.
NOTE
When this option is unchecked, the only images that are previewed are those where movement is detected. In this case, if no
event is found, the image does not change.
13. In the Search Option frame, adjust the Sensitiveness slide control for the percent of movement required to trigger an event.
The number of events appearing on the event log reects the sensitivity of the regions, i.e., 100% sensitivity generates more
events.
0% – Not sensitive to movement
100% – Very sensitive to any changes in the dened regions.
14. If you would like to speed up the search process, check the Quick Search option. Searches may be done up to 20% faster
using this option.
NOTE
During testing, a 10-minute recording was completed approximately 20% faster with Quick Search. Search times typically
take 60 seconds for 10 minutes of video. The Quick Search only reviews the “index” images and ignores the other images. In a
relatively motionless scene, this option could save considerable search time. If the Quick Search option is not selected, the search
feature reviews every image recorded.