User manual
32
www.digiop.com
SECTION 4: USING VIEWER
Table 2. Smart Search options
Item Name Description
1 Zoom Only impacts playback. (1) Choose a record. (2) Click Zoom. (3) Use the mouse scroll wheel to enlarge an area
(e.g., a square or block). (4) Click Play and the video plays back at that zoom magnication. At the end of the
playback or when a dierent video record is selected from the Smart Search list, the zoom magnication is
retained until the Zoom is clicked again and the mouse wheel is used. To disable Zoom, click the Go to start
playback control.
2 Speed slide control Only impacts playback. The playback speed varies depending on the frame rate at which the recording was
made. At the lowest setting, the video plays back at about 1 fps.
3 Search Next Movement Searches the video from the selected camera for motion events.
4 Search All Erases the current search event list and starts the search from the beginning again. The search can be stopped
but not paused. Events are listed by start/end times.
5 Stop Search Terminates the search completely (no pause option is available).
6 Print Prints the rst image of the search event.
Save Launches a folder browser where you can select the destination folder. A folder and le are created as either
a .BMP or .JPG. The folder/le format is: Folder and le – 20060118-071746.079-01. The name format
is:YYYYMMDD – HHMMSS.RRR – Cam# (where RRR is a 1/1000 second reference number).
7 Erase List The Erase List button erases the current search event list.
NOTE
Initially, the data area on the right is empty until you run a search. In this example, the Smart Search was already run so
some information is already shown.
7. In the Search eld, enter one of these options:
— Enter the Start Time and End Time or use the up and down arrows to select the time you want to run the Smart
Search.
OR
— Check the File Begin and File End checkboxes to match the start and end times to the available le content.
NOTE
By default, the system opens with the Start Time set to the beginning of the rst recording for that camera on the day selected
(initially, this is the same as the “File Begin” time). The End Time is the time the le ends (initially, this is the same as “File End”
time).
8. Click Go to Start to see where the video begins.
9. Adjust the Start Time and End Time as necessary to locate the desired video.
10. Place a check mark in the Search Area Section to place a Block or a Square to dene the search regions:
— Block – Click on the desired location on the image to add a xed-size square. You can add up to 20 horizontal and 15
vertical blocks to the image.