User manual
14
www.digiop.com
SECTION 3: USING DIGIOP™ CONTROL
3.6.1 A New Rule
A rule is an action for a device that triggered. To setup a rule, click New Rule on the Create Item menu. For specic information
about creating rules, refer to the appendix Creating Rules.
To create a rule:
1. Enter a name for the rule in the Name eld.
2. In the Schedule pull-down list, select the time when rule is run.
3. On the When pull-down list, select the condition on which the rule Action (see below) is executed.
4. Choose the Device on which to apply the rule.
5. In the Action pull-down list, select the action to perform when the device triggers.
NOTE
See the appendix Create Rule for information on rule creation, Action conguration parameters and examples.