User manual

5H.264 Network Video Encoder

SECTION 2: INSTALLATION AND SETUP

SECTION 2

Installation and Setup

2.1 What’s in the box

Your encoder includes the following:

• BLK-IPE101 encoder

• 12 V DC power adapter

• 9-pin terminal blocks (2)

• Hardware installation kit including mounting brackets (2), screws (4), and wall inserts (2)

• CD mini disk with application software, software manual, and encoder manual (this document)

2.2 Tools you need

To install the encoder, you will need:

• Phillips #2 screwdriver

• Drill 1/4” drill bit

• PC with Microsoft

Windows

XP SP3 or newer

2.3 Install the encoder

1. Determine where the encoder will be mounted and record the Media Access Control (MAC) address of the encoder. The MAC

address can be found on a label on the underside of the encoder. Record the information in the following table.

Location:

MAC address:

2. Slide the mounting brackets provided in the hardware kit into the slots on the side of the encoder.

3. Do one of the following:

— If the mounting surface is a hard material, use the 1/2” self-tapping mounting screws provided in the hardware kit to

secure the encoder to the surface.

— If the mounting surface is a soft material:

i. Using the encoder with the mounting brackets as a template, mark the location of the mounting screw holes.