User manual

30
www.digiop.com
APPENDIX A: TROUBLESHOOTING
APPENDIX A
Troubleshooting
A.1 Reboot encoder
NOTE
The reboot process lasts about 2 minutes, during which time the encoder will not respond to the IPAdmin Tool or transmit video
to a web browser
The encoder can be rebooted in two ways:
• Using the IPAdmin Tool:
a. Start the IPAdmin Tool.
b. Find the entry for the encoder you want to reboot and click it to select (highlight) it.
c. Click the Reboot button and enter the administrator ID and PW.
d. Click Refresh to re-discover the encoder.
• Using the reset button on the encoder:
a. Press and hold the reset button on the encoder for 5 seconds.
b. Click Refresh to re-discover the encoder.
A.2 Set encoder to factory default network settings
The encoder network settings can be forced to the factory default values:
Network settings acquired through DHCP on networks with DHCP
- OR -
Network settings forced to the following on networks were a DHCP server cannot be found:
— IP address – reset to 192.168.0.100
— Subnet mask – reset to 255.255.0.0
— Gateway – reset to 192.168.0.1
— User ID – reset to root
— Password – reset to pass