User manual
18
www.digiop.com
SECTION 2: INSTALLATION AND SETUP
c. Enter the subnet mask for your computer from Table 1 into the Subnet Mask eld.
d. Click SETUP. A Login window will open.
5. In the Login window, enter the ID and PW (password) for your encoder, then click Login. The default administrator ID and
PW are root and pass. After entering the ID and PW, the IP Setup window closes.
6. In the IPAdmin Tool window, click Refresh and verify that the entry representing the encoder now shows the new IP
address.
7. In the IPAdmin Tool window, click Refresh and verify that the entry for your encoder now shows the new IP address.
2.7 Setup the encoder Basic Conguration
In this procedure, use Microsoft Internet Explorer (IE) browser to setup the encoder administrator and user passwords, date, and
time.
1. Open the IE browser.
2. In the URL eld (Internet address), enter the IP address for your encoder in the format:
http://<IP address>/
where <IP address> is the IP address of your encoder. Following the example earlier in this guide, the entry would be:
http://192.168.1.201
3. If prompted to install an ActiveX control such as AxAll.cab (publisher Cap Co), follow screen prompts to install the software.
IE prompt to install ActiveX control