User manual

10
www.digiop.com
SECTION 2: INSTALLATION AND SETUP
RS-232C device wiring schematic
To connect an RS-232C device wiring to the encoder:
1. Route wiring from the RS-232C device interface to the encoder.
2. Strip 1/4” of insulation from TX, RX, and GND wires from the device and insert them into the upper terminal block RS-232C
TX, RS-232C RX, and RS-232C GND pins, respectively, as shown in the schematic above.
2.4.6 LAN, video, and power connections
1. Attach the network LAN cable to the RJ-45 connector on the encoder back panel. If the encoder is powered through the LAN
cable, DO NOT apply power to the encoder at this time.
2. Attach the video stream from your camera to the Vin BNC connector on the encoder.
3. If the encoder is not powered through the Ethernet (PoE), attach the DC12V adapter to the power connector on the encoder.
DO NOT apply power to the encoder at this time.
LAN and power connections