User manual
8
www.digiop.com
SECTION 2: INSTALLATION AND SETUP
Relay type sensor wiring schematic
To connect a sensor to the encoder:
1. Route sensor wiring to the encoder.
2. Strip 1/4” of insulation from one sensor’s sense and ground wires and insert them into the upper terminal block in the DI ch 1
and DI GND pin locations, respectively.
3. Strip 1/4” of insulation from another sensor’s sense and ground wires and insert them into the upper terminal block in the DI
ch 2 and DI GND pin locations, respectively.
2.4.3 Digital out (DO) connection
The encoder supports up to two digital out connections to reporting devices in the conguration shown in the schematic below.
Digital out wiring schematic
To connect digital out reporting device to the encoder:
1. Route leads from the digital out devices to the encoder.