User manual

www.digiop.com

SECTION 2: INSTALLATION AND SETUP

6. In the IPAdmin Tool window, click Refresh and verify that the entry representing the camera now shows the new IP address.

7. In the IPAdmin Tool window, click Refresh and verify that the entry for your camera now shows the new IP address.

2.7 Setup the camera Basic Conguration

In this procedure, Microsoft Internet Explorer (IE) browser is used to setup the camera administrator and user passwords, date, and

time.

1. Open the IE browser.

2. In the URL eld (Internet address), enter the IP address for your camera in the format:

http://<IP address>/

where <IP address> is the IP address of your camera. Following the example earlier in this guide, the entry would be:

http://192.168.1.201

3. If prompted to install an ActiveX control such as AxNVC.cab, follow screen prompts to install the software.

IE prompt to install ActiveX control

NOTE

To load these ActiveX controls, you may need to adjust the security settings of your browser to accept add-ins from

unknown publishers.