User manual

www.digiop.com

SECTION 2: INSTALLATION AND SETUP

b. Type cmd in the entry eld, then click OK to open the DOS command window.

c. At the command prompt, enter ipcong. The response will show the your PC’s network settings.

Example: Typical use of ipcong in Windows XP

d. Enter the IP Address, Subnet Mask, and Default Gateway for your PC’s Ethernet adapter into Table 1.

NOTE

The Ethernet adapter data you see by using ipcong will probably be dierent from that shown in the example

above. If you are using Windows Vista or Windows 7, the IP address is identied as the “IPv4 Address.”

Table 1. PC/Camera network settings

Computer (PC) Camera

IP Address

Subnet Mask

Default Gateway

CAUTION



If connecting your camera to an enterprise network, consult with your network administrator for the

camera IP address, subnet mask, and default gateway.