User manual
5Indoor/Outdoor Mini-Dome IP Camera
SECTION 2: INSTALLATION AND SETUP
Monitor
Speaker
Mic
LAN
Drop
Drop
Cable
Power
Adapter
Camera connections
1. Attach a monitor, speaker, and microphone to the appropriate camera drop cable connector as needed.
2. Attach a LAN drop cable to the RJ45 camera drop cable connector. If the camera is powered through the LAN cable, DO NOT
apply power to the camera at this time.
3. Connect a 12 VDC power adapter to the power cable connector on the drop cable. If the LAN drop cable carries Power over
Ethernet (PoE), this connection is optional. DO NOT apply power to the camera at this time. See Appendix C for more
information.
2.5 Install IPAdmin Tool
The IPAdmin Tool, included on the CD mini disk, is a utility that will discover cameras installed on your network and enable you
to perform the initial network setup for each camera. After a camera is setup on the network, the Microsoft Internet Explorer
®
web browser can be used to see video from the camera, set the camera’s password, date and time, nalize camera hardware
adjustments, and congure the camera for functional requirements.
The IPAdminTool can be loaded on a Microsoft Windows XP, Vista or Windows 7 operating system (32- or 64-bit). To use this utility
for the initial setup of your camera, your computer must be connected to the same network subnet as your camera.
At a computer on the same LAN (subnet) where your cameras will be installed, do the following: