User manual

4
www.digiop.com
SECTION 2: INSTALLATION AND SETUP
Cover
opener
Slot
Camera dome removal
3. Using the base as a template, mark the location of the three
mounting screw holes.
4. Drill mounting screw holes into the mounting surface:
— If the mounting surface is a soft material, such as
a drywall, drill and install drywall inserts for the
mounting screws.
OR
— If the mounting surface is a very soft material, such as
ceiling tile, place a wood block behind the tile and drill
holes for mounting screws long enough to secure the
base to the block.
OR
— If mounting the camera on a hard surface, such as
wood, drill the mounting screw holes into the surface
before attaching the camera.
5. Determine the drop cable routing. If routing the cable will be
routed hole through the mounting surface, drill a 3/4” hole for
the cable.
Drop Cable
Wall
Inserts
Mounting
Screws
6. Route the drop cable the mounting surface (if necessary), then attach the camera base to the mounting surface.
2.4 Connections
Connections to the camera for video out, audio in and out (microphone and speaker), power, and LAN are made at the drop cable.