User manual
43H.264 DVR User Manual
SECTION 7: FIRMWARE UPGRADE
SECTION 7
Firmware Upgrade
The rmware installed in your DVR will probably never need to be changed. If new rmware is released, however, upgrading the
rmware in your DVR may be recommended by DIGIOP.
The general instructions for upgrading rmware are included in this section. For additional information, specic instructions, and to
obtain a rmware upgrade le, contact DIGIOP Support at: 1.877.972.2522.
To upgrade the rmware in your DVR:
1. Obtain the rmware update le from DIGIOP Support. The rmware upgrade le is usually named:
“apph_xxxxxx.bin” where “xxxxxx” represents the revision level of the rmware.
2. Plug a USB ash drive into a PC and format it for FAT32, if necessary.
3. Create a new directory on the ash drive named “upgrade”.
4. Copy the rmware le to the upgrade directory on the ash drive.
5. Disconnect the ash drive from the PC and plug it into a USB port on the DVR.
6. Open the SETUP menu on the DVR, then open the SECURITY tab.
7. Select the User Password button.