User manual

21H.264 DVR User Manual
SECTION 3: SYSTEM SETUP
Item Description
SET DATE & TIME
To set the date and time, move the cursor to SET DATE & TIME submenu button using the p, q, t, and u buttons, then
press the SEL button.
In the SET DATE & TIME window, use the t and u buttons to change the timestamp component value, then press SEL to
conrm it and move to the next eld. To move to another eld without changing it, use the p and q buttons. Highlight
the OK button and press SEL to conrm your selection and close the window, or press ESC button to return to SYSTEM setup
menu.
DAY LIGHT SAVING: Move the cursor to DAYLIGHT SAVING using the p and q buttons, change the option shown with the
t and u buttons, then press SEL to conrm your selection. Select the appropriate daylight saving time zone using the p,
q, t, and u buttons. If choosing EU or OTHERS, set the applicable conditions. The options are:
USA: Applies the USA daylight saving time.
EU: Applies the EU daylight saving time. Select the GMT AREA and the time dierence from standard time using the p, q,
t, and u buttons.
OTHERS: If the time zone is neither USA nor EU, set the BEGIN and END date and time of the daylight saving period using the
p, q, t, and u buttons, then press the SEL button. Press the ESC button to return to SET DATE & TIME setup menu.
CAUTION: Do not set the start time to 23:00 for DLS. DLS can’t be applied if the date of BEGIN and END is the same.
CLIENT ACCESS Enable/Disable remote access through network client software.
BANDWIDTH
SAVING
Enable/Disable only key frame transmission. “ON” mode is recommended for use on low-bandwidth networks. Set to “OFF”
for normal use.
SEND EMAIL Enable/disable the send email feature (ON/OFF).
TRANSMISSION MODE: When an alarm is triggered, send an image of only the channel that triggered the alarm.
IP NOTIFICATION: Enable/disable sending email when the IP address of your DVR is changed.
EVENT ALARM: When an alarm is triggered, enable/disable sending email reports of the channel that triggered the alarm.
MAIL TO: Use the virtual keyboard to enter the email address of the recipient.
MAIL SERVER: Use the virtual keyboard to enter the mail server information.
ID: Use the virtual keyboard to specify the user ID for the mail server.
PASSWORD: Use the virtual keyboard to specify the connection password for the mail server.
MAIL FROM: Use the virtual keyboard to specify the email address sent to the destination host.