Setup guide

8
» WIth OptiPlex chassis, lift the cover release latch, then lift the cover up and o the chassis.
Lift cover at
this edge rst
Cover release
latch
XE, 790, 7010 desktop chassis - remove side cover (7010 chassis shown)
Cover release
latch
Lift cover at
this edge rst
960, 990, 9010 minitower chassis - remove side cover (990 chassis shown)
6. Determine the location where the controller board should be installed in your computer. See the guidelines below for your server chassis and system.
Dell Power Edge R210 II chassis – AI45 series system
Install the STR-CTRL controller card in the expansion slot. This slot is normally empty.
Optiplex XE chassis – EH30/EH35 series systems
Install the STR-CTRL controller card in the fourth slot from the left (right-most slot) when looking at the computer backpanel. Normally the fourth slot is empty.
Original expansion card conguration Suggested conguration with STR-CTRL controller
STR-CTRL