Setup guide

7
c. Remove the two faceplate retaining screws, then separate the faceplate from the board.
d. Attach the half-height faceplate to the board using the screws removed in the previous step. Tighten the screws until snug. Over tightening the screws can damage the board.
Half-height faceplate installed
Faceplate attachment screw
Faceplate attachment screw
e. Return the board to the electrostatic protective packaging removed previously.
2. Power o your DIGIOP server hardware (computer).
3. Unplug the power cord from the back of the chassis, then disconnect ALL other cables from the chassis. Wait 30 seconds before continuing to allow components in the chassis to discharge.
4. If necessary, move the chassis to a clean surface where it is away from high voltage devices such as CRTs and power panels.
5. Remove the chassis side cover to gain access to the internal components of the computer.
a. Lay the chassis on its side (mini-tower models) or upright (desktop models), then remove the cover.
» WIth the PowerEdge R210 chassis, turn the cover release lock to the unlocked position (left). Slide the cover back about 1/2 inch, then lift it o the chassis.
LockUnlock
Cover release lock
Dell PowerEdge R210 cover removal