Setup guide

5
— For square-hole racks, extend the outer channel so that the tangs at each end t into the square holes in the vertical rack posts. Secure the channel to the rack using hardware provided with the
rack.
— For round-hole racks, attach the rack brackets provided in the kit to the vertical rack posts. Install two brackets for each outer channel - one on each of the front post, and one on each of the back
post - using screws provided with the rack. See the example below.
Rack brackets (two provided for each rail)
Screws
Rack bracket
for round-hole
racks
Rack post
(front or back)
Inside view
— For round-hole racks, connect the outer channels to the rack brackets as you would for a square-hole rack. Secure the channel to the post with a retention screw provided with the rack hardware.
Rail outer channel
Hole for outer
channel retention
screw
Rack bracket
for round-hole
racks
5. Install the chassis in the rack by aligning the inner channels on the chassis with the outer channels in the rack, then carefully slide the chassis into place.
6. Secure the chassis to the rack using hardware provided with the rack. Holes are provided in the chassis handle brackets for this purpose.
B. Install HDDs into the SV4000 chassis
Electrostatic Discharge Warning
Electronic modules including the HDDs STR-CTRL controller board, and parts inside the DIGIOP® server chassis contains components that can be damaged by electrostatic discharge (ESD). Always follow
recommended ESD procedures when handling this board and other components inside computers. Use a grounded wrist strap and ESD approved clothing.
Each HDD is labeled for the bay it should be installed into. Drive 1 should be installed in Bay 1, Drive 2 in Bay 2, etc.
1. Set the power switches on the back of the SV4000 chassis to “o” ( O ). There are three switches, the chassis power switch, and one switch on each power module.