Setup guide

21
d. In the Drive Selection menu, select Custom Selection, then
e. In the drive list, select only the drives you want to use for archival storage.
NOTE
DO NOT select the C:\ drive (system drive)
The D:\ drive is the remainder of the internal hard drive.
Do not select any storage that you do not want to use for archives.
f. Click OK to save the setting. Your SV4000 is now setup and ready for use with your DIGIOP ELEMENTS™ system.
SV4000 Storage Vault Specications
GENERAL
Number of Expander Single/Dual
Expander Chip LSISAS2x28
Host Interface Single Mini SAS 4x connector
Expansion Interface Single Mini SAS 4x connector
Transfer Bandwidth 2,400MB/s per connector
DRIVES SUPPORTED
Drive Interface 3.0/6.0 Gb dual ported SAS, 1.5/3.0/6.0 Gb single ported SATA
Drive RPM Up to 15,000
Form Factor 3.5”, 1” height
ADMINISTRATION / MANAGEMENT
Admin/Firmware Upgrade In-band and Out-of-band, Serial port via Hyper terminal
LED Indicators, Audible Alarm Yes
HOT-SWAP & REDUNDANCY
Disk Drive (HDD) Front accessible HDD trays in 12 bay
Cooling 2 x hot-swap blowers
Power Supplies 500 W 1+1 hot-swap redundant 80+ (Sliver)
Power Entry Dual AC Inlet
ELECTRICAL & ENVIRONMENTAL
Universal A/C Input 100 ~ 240 Vac full range
Operating Environment Temperature 32 ºF to 95 ºF (0 ºC to 35 ºC), Relative humidity 20% to 80%
Non-operating Environment Temperature -4 ºF to 140 ºF (-20 ºC to 60 ºC), Relative humidity 10%
to 90%
PHYSICAL SPECIFICATION
Dimensions (W x D x H) 19 x 18.94 x 3.50 in (482.6 x 481 x 88.8 inches: 19 x 19 x 3.5 mm)
Gross Weight (w/ PSU; w/o Rail & Disks) 33 lb (15 kg)
Packaging Dimension (W x D x H) 23.62 x 28.74 x 11.34 in (600 x 730 x 288 mm)
Cubic Feet 5.2
Mounting Option Adjust plate or toolless rail (optional)