Setup guide

19
11. Open the Disk Management window. In the window shown below, note that volumes 1, 2, 3 and 4 (drives E, F, G and H) of the SV4000 are shown. Verify that for each of these drives have the Status of
Healthy (Primary Partition).
12. Open the Windows le explorer, then open the directory: C:\\DiSSTech\Bin.
13. If you are using a version of DIGIOP ELEMENTS™ before V8.5, skip this step and continue with Step 14. Otherwise, do the following:
a. In the le list, use Notepad (Edit) to open the le DiSSFactory.ini.
b. In the DiSSFactory.ini le, nd the entry NO_MCU=1 and insert the following two lines after it:
DRIVESELECTION=1
CUSTOMDRIVEMASK=00000000000000000000000000
where each digit of the 26 digit CUSTOMDRIVEMASK represent a drive letter, A to Z, left to right, of the drives installed in the SV4000 as follows: if the digit is a “1”, the respective drive letter is part of
the SV4000. All other digits are “0”.
In the example used above, with drives E, F, G and H installed in the SV4000, the CUSTOMDRIVEMASK is: 0000111100000000000000000
c. Save the edited DiSSFactory.ini le, and then close Notepad.
d. Skip the following steps. Your SV4000 is now setup and ready for use with your DIGIOP ELEMENTS™ system.