Setup guide

18
5. In the Change Drive Letter or Path pop-up window, select Assign the following drive letter, select Z form the drop down list, then click OK. If a verication window opens, click OK to continue.
6. In the Disk Management screen, verify that the CD-ROM drive letter changed to “Z”.
Connecting the DIGIOP server to the SV4000 chassis
7. Power o the DIGIOP server.
8. Connect one end of the SAS cable to the mini SAS port UP connector on the pack of the SV4000 chassis. Connect the other end of the SAS cable to the controller card installed in the DIGIOP server.
SV4000 SAS cable “UP” connectorController card and cable in DIGIOP® server
9. Power on the SV4000 chassis as follows:
a. Set the two power module power switches to “on” (I).
b. Set the SV4000 chassis power switch to “on” (I).
c. Wait at least 30 seconds for the SV4000 to power on and fully initialize.
10. Power on the DIGIOP® server chassis and allow it to fully initialize.