Setup guide

14
ii. Place the STR-CTRL card into place (see above), then slide it into the card connecter on the riser.
iii. Close the expansion card latch.
— In OptiPlex chassis, the slot in the upper faceplate tab should surround the alignment pin in card retention latch assembly (see below).
Card retention
latch assembly
Correct positioning
of upper faceplate tab
Upper tab of
faceplate
Proper positioning of XE, 780, 790, 7010 expansion card faceplates
Card retention
latch assembly
Correct positioning
of upper faceplate tab
Upper tab of
faceplate
Proper positioning of 960, 990, 9010 expansion card faceplates
8. In the PowerEdge R210 chassis, ensure the card is fully seated in the riser. and the card faceplate aligns with the opening on the back of the chassis.
In OptiPlex chassis, roll the card retention latch assembly back into place. The tab should snap into position to lock it.
9. Reinstall the chassis cover.
10. Reconnect all cables to the chassis.
NOTE
DO NOT attach the SAS cable to the controller or power on the SV4000 chassis at this time.
D. Install drivers for the STR-CTRL controller card
1. Power on the DIGIOP server chassis and allow it to fully initialize. Depending on your BIOS conguration, Windows may try to boot through the RocketRAID card; ignore this option; allow the server to
initialize normally.