Setup guide

13
Optiplex 9010 chassis – AH41 series systems
Install the STR-CTRL controller card in the fourth slot from the left (right-most slot) when looking at the computer backpanel. Because this slot is full, the analog audio card in the slot must be removed.
The analog audio card can be installed in the second slot from the left if the NIC is removed, or left out if not needed.
Original expansion card conguration Suggested congurations with STR-CTRL controller
STR-CTRL
NIC
Analog
audio
card
STR-CTRL
System without NIC – or – System without analog audio card
Optiplex 9010 chassis – AI51 series systems
Move the network interface card (NIC) to the second slot from the left, then install the STR-CTRL in the fourth slot from the left.
Original expansion card conguration Suggested conguration with STR-CTRL controller
NIC
NIC
STR-CTRL
7. Install the STR-CTRL controller card in the suggested location, rearranging other cards in the chassis if necessary. Make sure the board edge connectors of all cards are fully seated in their mainboard
connectors, and the faceplate is positioned properly.
— In the PowerEdge R210 chassis, the faceplate should align with the opening on the backpanel.
i. Lift open the expansion card latch (see below) and remove the card slot ller bracket.
Expansion card riser
Card slot
ller bracket
Expansion card
latch (shown open)
Expansion card
latch (closed)
STR-CTRL card installed
PowerEdge R210 expansion card installation