User's Manual

Using your Care Pal dongle
1. Turn on your laptop or computer.
Problems
LED display does not light up No power Make sure that your PC is powered on.
Network LED display turns Orange Network is oine Check your PC network is workable.
Bluetooth LED display turns Orange Bluetooth is disable Unplug your dongle and insert it again.
Cause Suggested Actions
2. Insert the Care Pal dongle in an available USB 2.0 port on your
laptop or computer.
3. Turn on the bluetooth device you would like to pair with your
Care Pal dongle.
IMPORTANT! Ensure that all the devices are within a 3-meter range from
the dongle.
4. The following screen appears to prompt you to input your current
data using the compatible bluetooth device.
Safety tips when using your Care Pal dongle
Marks and Abbreviation
Troubleshooting
•
device.
•
•
is also removed to avoid overwriting it with new data.
ISO 7010-M001
ISO 7010-M002
IEC 60417-5031
General mandatory acon sign
Refer to instrucon manual/booklet
NOTE: On ME EQUIPMENT “Follow instrucons for use”
Direct current
WARNING – if the enclosure of this device is damaged, please do not use it, electrical shock hazard may
occur.
WARNING - Do not modify this equipment without authorizaon of the manufacturer.
Accessory equipment connected to the analog and digital interfaces must be in compliance with the
respecve naonally harmonized IEC standards (i.e. IEC 60950 for data processing equipment, IEC 60065
for video equipment, IEC 61010-1 for laboratory equipment, and IEC 60601-1 for medical equipment.)
Furthermore all configuraons shall comply with the system standard IEC 60601-1-1. Anyone who
connects addional equipment to the signal input part or signal output part is configuring a medical
system, and is therefore, responsi¬ble that the system complies with the requirements of the system
standard IEC 60601-1-1. The unit is for exclusive interconnecon with IEC 60601-1 cerfied equipment in
the paent environment and IEC 60XXX cerfied equipment out¬side of the paent environment. If in
doubt, consult the technical services department or your local representave.