Instruction manual

-8-
INSTALLATION. INDOOR DOME (Surface Fitting)
1a) Press down on the tab marked with an arrow to lift
up the dome cover slightly
1b) While pressing on tab, twist the dome cover
counter clockwise just a few degrees to release
dome cover from back clips.
Lift off the cover.
Note: If you plan on installing onto a junction box,
attach provided mounting plate rst to the
junction box and then attach camera base
to the mounting plate.
3a) Reinsert camera module into camera base
by ligning up the arrow notches, and turning
camera module clockwise to lock into place.
3b) Reinstall the base locking screws. (indicated by
padlock markings)
Go to step
3
on page 9 to complete installation.
Method 1 - Direct Attach Install
2a) Use included mounting template to mark and pre-
drill the required holes. Use included 2.8” screws
to mount the camera directly to the mounting
surface.
Go to step
3
on page 9 to complete installation.
OR
Method 2 - Camera Base Install
Note: Use this method if installing onto junction box
plate.
2b) Remove the camera base by unscrewing the base
locking screws (indicated by padlock markings)
and turn camera module approx. 5 degrees
counter-clockwise to detach camera base from the
camera module. Install the base as indicated using
the 1.2” screws.
1
3
a
a
b
a
b
b
2